Sign & Digital Graphics

2015 WRAPS

Issue link: https://nbm.uberflip.com/i/439679

Contents of this Issue

Navigation

Page 109 of 166

2015 I WRAPS I 93 3) I have the vinyl in position, making sure the registration matches the door. Notice that I have trimmed excess vinyl away to get accurate registration. 5) Start by lightly tacking vinyl, making sure the artwork matches. 7) Now that I have a good portion in place I can unroll the vinyl and strike a nice even area across the fender toward the front. 6) Once I have the vinyl tacked, I remove my magnets and roll the vinyl up so it is easier to hold in my hand. Then begin to work the squeegee across the fender. 8) Squeegee the vinyl over the contour of the fender in a typewriter fashion until you reach the antenna, then stop. 4) I am using a vertical hinge to make registration easier, exposing about 6 inches of vinyl for my initial tack.

Articles in this issue

view archives of Sign & Digital Graphics - 2015 WRAPS