Awards & Engraving

June '16

Issue link: https://nbm.uberflip.com/i/677454

Contents of this Issue

Navigation

Page 56 of 83

A&E JUNE 2016 • a-e-mag.com 55 Sandcarving To get started, I took some butcher paper with me and made a rubbing of each door panel, carefully labeling each and noting from which side of the door it was made. We also had two of the broken panels: one of the originals and one re-make. From the rubbing, we made an accurate drawing that we then had a company scan for us so that we could make the template for the glass panels to be ordered. The glass company we dealt with could not work from a scan but wanted an actual template. In the past, I would have made a rubbing from the design as well, but nowadays, we proceed a little different. Damian, from our graphics department, took several pic- tures with his high-resolution camera and imported the design into Adobe Illustrator. He could then work on rep- licating the design while we waited on the glass pieces to be made. DESIGN CONSIDERATIONS AND WAITING There are some projects where the solution offers itself instantly and others, like this one, where I have to think about it for a while before the path becomes evident. This phase is the A close-up of one of the corner details to show the wheel cut design a bit better. Make Money Fast with Sandcarving R AY Z I S T. C O M | 8 0 0 . 7 2 9.9 47 8 — High Profit Margin — Minimal Investment — New Revenue Stream — Easy to use, no skill required — Low Operating Cost — Ergonomic Height Adjustment

Articles in this issue

Links on this page

view archives of Awards & Engraving - June '16